Check power to the socket and reconnect pool cleaner.
Maytronics power supply not turning on.
We had been using it then i shut it off to clean out filter and it will not come back on.
Close the unit casing turn it on and let it run.
A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c.
Wait 30 seconds then turn it back on.
In essence what you ve just done is zero out the sensor.
Turn the power supply off.
What about damaged filters.
As a result that light shouldn t turn on again until the filters begin to fill up or are full.
Going to start a thread to see if anyone has attempted this.
Pair via bluetooth to your dolphin not a neighbor s.
Open the impeller cover and check that nothing is trapped in the impeller.
After 1 min connect your smartphone to wifi.
Unplug the power supply.
It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.
Check the label on your transformer for voltage output and type.
Unplug the power supply.
You can program the power supply at any time.
Power supply not rated yet our power supply for our dolphin 3001 will not turn on.
Wait 30 seconds then turn it back on.
Plug the power supply into an electrical outlet.
Open the impeller cover and check that nothing is trapped in the impeller.
See the relevant section below for more details on each program.
Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.
Are you happy with what you learned here.
You ll know the app is connected if the power supply buttons are overridden in disable mode.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
There may be a problem with the blue cable or the dolphin cleaner itself.
Take it to your local dealer for further testing or call maytronics customer service.
The pool cleaner moves but.
We had been using it then i shut it off to clean out filter and it will not come back on.
Press the on button the leds will turn on and the robot will start to operate.
Output voltage should be about 38 volts d c.
Wait 30 seconds then turn it back on.
Turn the power supply off.
If no program is selected the robot will perform a single cleaning cycle.
Unplug the blue cable from the power supply unit psu and turn it on.
If the outlet is receiving power.
