Making Your Own Gutter Guards

Add 2 inches to the length and width measurements to obtain the final measurement result.

Making your own gutter guards.

The mesh won t really need it since it will either be aluminum or galvanized. Cut wire mesh sections using a. One important detail to keep in mind is that screws are needed to secure the each splashguard to your gutters. You will need wire mesh which is sold in 100 foot aluminum rolls that are 8 inches wide.

They can be cut into 4 inch wide rolls using the hacksaw. You may need to buy a new section if a scrap piece is not available. Spray paint the mesh to provide enhanced rust oxidation protection. Mesh is also available in 4 to 8 foot sheets and they can be painted to fit the exterior of your house.

Using the hacksaw cut the roll s of mesh in half making 2 rolls 4 inches wide. The best way to make a gutter splashguard is to use a scrap piece of downspout. Making your gutter guard. Don t waste money make your own diy gutter guard.

Measure the length and width of each gutter section with a measuring tape and mark the measurements on a notepad.