Make Your Own Awning From Pipes

Make sure you use a sturdy ladder if drilling holes that are high.

Make your own awning from pipes.

Attach flagpole brackets to the exterior of your house by drilling holes at the appropriate height. Kee klamp fittings are similar to traditional threaded pipe fittings yet they connect by sliding over pipe and tightening down a set screw on the fitting. The outer pipe has one hole and the inner pipe attached to the awning has multiple holes. Slide canvas onto frame.

1 1 4 pvc piping 1 bag of the cheapest cement mix you can find 4 large cans beans ketchup coffee saw measuring tape pencil white spray paint velcro sticky back squares 1 queen size sheet for the canopy 6 yards of fabric 3 in each. You ll need 1 2 pvc pipe the t s and elbows shown here pvc cutters and. This is the cheapest canvas drop cloth i. Drill one hole about an inch down from the top of the larger pipe.

Use a d pin or something fancier to set the height. Things you ll need measuring tape 1 inch pvc pipe pvc cutters 1 inch pvc elbows 1 inch pvc tees outdoor upholstery fabric or canvas pvc snap clamps 1 inch conduit clamps 2 2 inch wood screws. Dry fit the frame. With kee klamp it s possible to build all sorts of shade structures using just a few basic tools such as a drill and an allen wrench.

Insert two connectors to both the ends of the side pipes to attach them to the flagpoles. Before you get started here is what you are going to need. Diy awning step 1. Start by making the frame.